Resequence Prefix-List Ipv4 - Dell Z9500 Reference Manual

Version
7.4.1.0
Usage
When you have exhausted all the sequence numbers, this feature permits re-
Information
assigning a new sequence number to entries of an existing access-list.
Related

resequence prefix-list ipv4

Commands
resequence prefix-list ipv4
Re-assign sequence numbers to entries of an existing prefix list.
Z9500
Syntax
resequence prefix-list ipv4 {prefix-list-name StartingSeqNum
Step-to-increment}
Parameters
prefix-list-
name
StartingSeqNu
m
Step-to-
Increment
Defaults none
Command
•
Modes
•
Command
This guide is platform-specific. For command information about other platforms,
History
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version
9.2(1.0)
8.3.11.1
8.1.1.0
7.8.1.0
7.6.1.0
7.5.1.0
7.4.1.0
218
Description
Introduced on the E-Series.
Enter the name of the configured prefix list, up to 140
characters long.
Enter the starting sequence number to resequence. The
range is from 0 to 65535.
Enter the step to increment the sequence number. The
range is from 1 to 65535.
EXEC
EXEC Privilege
Description
Introduced on the Z9500.
Introduced on the Z9000.
Introduced on the E-Series ExaScale
Increased the name string to accept up to 140 characters.
Prior to 7.8.1.0, names were up to 16 characters long.
Introduced on the S-Series.
Introduced on the C-Series.
Introduced on the E-Series.
— resequences a prefix list.
Access Control Lists (ACL)