Set Weight - Dell Z9500 Reference Manual

Hide thumbs Also See for Z9500:

Table of Contents

set automatic-tag

set metric-type

set weight

To add a non-RFC compliant attribute to the BGP route to assist with route selection, configure a filter.

set weight weight

To delete a weight specification, use the no set weight weight command.

router-originated = 32768; all other routes = 0

Not configured.

This guide is platform-specific. For command information about other platforms,

refer to the relevant Dell Networking OS Command Line Reference Guide.

The following is a list of the Dell Networking OS version history for this command.

Introduced on the S4810.

Introduced on the E-Series ExaScale.

Introduced on the S-Series.

Introduced on the C-Series.

Introduced on the E-Series.

— computes the tag value of the route.

— specifies the OSPF area for route redistribution.

— specifies the metric value assigned to redistributed routes.

— specifies the route type assigned to redistributed routes.

Enter a number as the weight used by the route meeting the

route map specification. The range is from 0 to 65535. The

default is router-originated = 32768 and all other routes = 0.

When there are multiple routes to the same destination, the

routes with a higher weight are preferred.

Introduced on the Z9500.

Introduced on the S4820T.

Access Control Lists (ACL)