Dcb-Map; Dcb-Map Sfm All Backplane All - Dell Z9500 Reference Manual

dcb-map

Create a DCB map to configure priority flow control (PFC) and enhanced transmission selection (ETS) on
Ethernet ports that support converged Ethernet traffic. Apply the DCB map to an Ethernet interface.
Syntax
dcb-map map-name
Parameters
map-name
Defaults None. There are no pre-configured PFC and ETS settings on S5000 Ethernet
interfaces.
Command CONFIGURATION
Modes
INTERFACE
Command
Version
History
9.7(0.0)
Usage
A DCB map is a template used to configure DCB parameters and apply them on
Information
converged Ethernet interfaces. DCB parameters include priority-based flow control
(PFC) and enhanced traffic selection (ETS).
To display the PFC and ETS settings in DCB maps, enter the show qos dcb-map
command.
Use the dcb-map command to create a DCB map to specify PFC and ETS settings
and apply it on Ethernet ports. After you apply a DCB map to an interface, the PFC
and ETS settings in the map are applied when the Ethernet port is enabled. DCBx is
enabled on Ethernet ports by default.
The dcb-map command is supported only on physical Ethernet interfaces.
To remove a DCB map from an interface, enter the no dcb-map map-name
command in Interface configuration mode.

dcb-map sfm all backplane all

Assign the specified DCB Map on all backplane ports of the switch linecard.
Syntax
dcb-map sfm all backplane all <dcb-map-name>
Parameters
map-name
Defaults none
596
Enter a DCB map name. The maximum number of
alphanumeric characters is 32.
Description
Introduced on the Z9500.
Enter a DCB map name. The maximum number of
alphanumeric characters is 32.
Data Center Bridging (DCB)