Border Gateway Protocol
BGP is an external gateway protocol that transmits interdomain routing information within and between
autonomous systems (AS). BGP version 4 (BGPv4) supports classless inter-domain routing (CIDR) and the
aggregation of routes and AS paths. Basically, two routers (called neighbors or peers) exchange
information including full routing tables and periodically sent messages to update those routing tables.
BGP is supported in
NOTE: For more information about configuring the border gateway protocol (BGP), refer to the BGP
chapter in the Dell Networking OS Configuration Guide.
This chapter contains the following sections:
•
BGPv4 Commands
•
MBGP Commands
•
BGP Extended Communities (RFC 4360)
•
IPv6 BGP Commands
BGP IPv4 Commands
Border Gateway Protocol (BGP) is an external gateway protocol that transmits interdomain routing
information within and between Autonomous Systems (AS). BGP supports classless interdomain routing
(CIDR) and the aggregation of routes and AS paths. Basically, two routers (called neighbors or peers)
exchange information including full routing tables and periodically send messages to update those
routing tables.
address-family
Enable the IPv4 multicast or the IPv6 address family.
Z9500
Syntax
address-family [ipv4 {multicast | vrf vrf-name} | ipv6 unicast
[vrf vrf-name]]
Parameters
ipv4 multicast
ipv4 vrf vrf-
name
338
Enter the keyword ipv4 followed by the keyword
multicast to enable BGPv4 multicast mode.
Enter the keyword ipv4 followed by the keyword vrf and
then the name of the VRF to enable VRF mode.
8
Border Gateway Protocol