Dcbx Version - Dell Z9500 Reference Manual

Defaults Manual
Command INTERFACE PROTOCOL LLDP
Modes
Command
This guide is platform-specific. For command information about other platforms,
History
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version
9.7(0.0)
Usage
DCBX requires that you enable LLDP to advertise DCBX TLVs to peers.
Information
Configure DCBX operation at the INTERFACE level on a switch or globally on the
switch. To verify the DCBX configuration on a port, use the show interface
dcbx detail command.

dcbx version

Configure the DCBX version used on the interface.
Syntax
dcbx version {auto | cee | cin | ieee-v2.5}
To remove the DCBX version, use the dcbx version {auto | cee | cin |
ieee-v2.5} command.
Parameters
auto | cee | cin
| ieee-v2.5
Defaults Auto
Command INTERFACE PROTOCOL LLDP
Modes
Command
This guide is platform-specific. For command information about other platforms,
History
refer to the relevant Dell Networking OS Command Line Reference Guide.
590
• manual: configures the port to operate only on
administer-configured DCB parameters. The port does
not accept a DCB configuration received form a peer or a
local configuration source.
Description
Introduced on the Z9500.
Enter the DCBX version type used on the interface, where:
• auto: configures the port to operate using the DCBX
version received from a peer.
• cee: configures the port to use CDD (Intel 1.01).
• cin: configures the port to use Cisco-Intel-Nuova (DCBX
1.0).
• ieee-v2: configures the port to use IEEE 802.1az (Draft
2.5).
Data Center Bridging (DCB)