Neighbor Weight - Dell Z9500 Reference Manual

Version
7.8.1.0
7.7.1.0
Usage Loopback interfaces are up constantly and the BGP session may need one
Information interface constantly up to stabilize the session. The neighbor update-source
command is not necessary for directly connected internal BGP sessions.

neighbor weight

Assign a weight to the neighbor connection, which is used to determine the best path.
Z9500
Syntax
neighbor {ip-address | peer-group-name} weight weight
To remove a weight value, use the no neighbor {ip-address | peer-
group-name} weight command.
Parameters
ip-address
peer-group-
name
weight
Defaults 0
Command ROUTER BGP
Modes
Command
This guide is platform-specific. For command information about other platforms,
History
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version
9.2(1.0)
8.3.19.0
8.3.11.1
8.3.7.0
7.8.1.0
7.7.1.0
Border Gateway Protocol
Description
Introduced on the S-Series.
Introduced on the C-Series.
Enter the IP address of the peer router in dotted decimal
format.
Enter the name of the peer group to disable all routers within
the peer group.
Enter a number as the weight. The range is from 0 to 65535.
The default is 0.
Description
Introduced on the Z9500.
Introduced on the S4820T.
Introduced on the Z9000.
Introduced on the S4810.
Introduced on the S-Series.
Introduced on the C-Series.
413