Route-Map - Dell Z9500 Reference Manual

Defaults Not configured.
Command

ROUTE-MAP

Modes
Command
This guide is platform-specific. For command information about other platforms,
History
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version
9.2(1.0)
8.3.19.0
8.3.11.1
8.3.7.0
8.1.1.0
7.6.1.0
7.5.1.0
6.1.1.0
Related
match interface
Commands
match ip address
match ip next-hop
match ip route-source
routers.
match metric
match route-type
route-map
Enable a route map statement and configure its action and sequence number. This command also places
you in ROUTE-MAP mode.
Z9500
Syntax
route-map map-name [permit | deny] [sequence-number]
To delete a route map, use the no route-map map-name [permit | deny]
[sequence-number] command.
Parameters
map-name
Access Control Lists (ACL)
Description
Introduced on the Z9500.
Introduced on the S4820T.
Introduced on the Z9000.
Introduced on the S4810.
Introduced on the E-Series ExaScale.
Introduced on the S-Series.
Introduced on the C-Series.
Introduced on the E-Series.
— redistributes routes that match the next-hop interface.
— redistributes routes that match an IP address.
— redistributes routes that match the next-hop IP address.
— redistributes routes that match routes advertised by other
— redistributes routes that match a specific metric.
— redistributes routes that match a route type.
Enter a text string of up to 140 characters to name the route
map for easy identification.
303