Dell Z9500 Reference Manual page 215

mask
any
host ip-address
count
byte
dscp
order
fragments
log
threshold-in
msgs count
interval
minutes
monitor
Defaults Not configured.
Command CONFIGURATION-STANDARD-ACCESS-LIST
Modes
Access Control Lists (ACL)
(OPTIONAL) Enter a network mask in /prefix format (/x) or
A.B.C.D. The mask, when specified in A.B.C.D format, may be
either contiguous or non-contiguous.
Enter the keyword any to specify that all routes are subject
to the filter.
Enter the keyword host then the IP address to specify a host
IP address.
(OPTIONAL) Enter the keyword count to count packets that
the filter processes.
(OPTIONAL) Enter the keyword byte to count bytes that the
filter processes.
(OPTIONAL) Enter the keyword dcsp to match to the IP
DSCP values.
(OPTIONAL) Enter the keyword order to specify the QoS
priority for the ACL entry. The range is from 0 to 254 (where
0 is the highest priority and 254 is the lowest; lower-order
numbers have a higher priority). If you do not use the
keyword order, the ACLs have the lowest order by default
(255).
Enter the keyword fragments to use ACLs to control packet
fragments.
(OPTIONAL) Enter the keyword log to include ACL
messages in the log.
(OPTIONAL) Enter the threshold-in-msgs keyword
followed by a value to indicate the maximum number of ACL
logs that can be generated, exceeding which the generation
of ACL logs is terminated with the seq, permit, or deny
commands. The threshold range is from 1 to 100.
(OPTIONAL) Enter the keyword interval followed by the
time period in minutes at which ACL logs must be generated.
The threshold range is from 1 to 10 minutes.
(OPTIONAL) Enter the keyword monitor when the rule is
describing the traffic that you want to monitor and the ACL
in which you are creating the rule is applied to the monitored
interface. For more information, refer to the "Flow-based
Monitoring" section in the Port Monitoring chapter of the
Dell Networking OS Configuration Guide.
215