Set Metric-Type - Dell Z9500 Reference Manual

Defaults Not configured.
Command ROUTE-MAP
Modes
Command
This guide is platform-specific. For command information about other platforms,
History
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version
9.2(1.0)
8.3.19.0
8.3.11.1
8.3.7.0
8.1.1.0
7.6.1.0
7.5.1.0
6.1.1.0
Related
set automatic-tag
Commands
set level

set metric-type

set tag
set metric-type
To assign a new route type for routes redistributed to OSPF, configure a filter.
Z9500
Syntax
set metric-type {internal | external | type-1 | type-2}
To delete a setting, use the no set metric-type command.
Parameters
internal
external
type-1
type-2
312
Description
Introduced on the Z9500.
Introduced on the S4820T.
Introduced on the Z9000.
Introduced on the S4810.
Introduced on the E-Series ExaScale.
Introduced on the S-Series.
Introduced on the C-Series.
Introduced on the E-Series.
— computes the tag value of the route.
— specifies the OSPF area for route redistribution.
— specifies the route type assigned to redistributed routes.
— specifies the tag assigned to redistributed routes.
Enter the keyword internal to assign the Interior Gateway
Protocol metric of the next hop as the route's BGP
MULTI_EXIT_DES (MED) value.
Enter the keyword external to assign the IS-IS external
metric.
Enter the keyword type-1 to assign the OSPF Type 1 metric.
Enter the keyword type-2 to assign the OSPF Type 2 metric.
Access Control Lists (ACL)