Interface Range - Dell Z9500 Reference Manual

Command CONFIGURATION
Modes
Command
This guide is platform-specific. For command information about other platforms,
History
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version
9.2(1.0)
8.3.19.0
8.3.11.1
8.3.7.0
8.1.1.0
7.6.1.0
7.5.1.0
6.4.1.0
Usage You cannot delete the Null interface. The only configuration command possible in
Information a Null interface is ip unreachables.
Example
Dell(conf)#interface null 0
Dell(conf-if-nu-0)#
Related
interface
Commands
interface loopback
interface port-channel
interface vlan
ip unreachables
unreachable messages.

interface range

This command permits configuration of a range of interfaces to which subsequent commands are
applied (bulk configuration). Using the interface range command, you can enter identical commands
for a range of interface.
Z9500
Syntax
interface range interface {slot/port | port} — port}, interface
{slot/port | port} — port},...
816
Description
Introduced on the Z9500.
Introduced on the S4820T.
Introduced on the Z9000.
Introduced on the S4810.
Introduced on the E-Series ExaScale.
Introduced on the S-Series.
Introduced on the C-Series.
Introduced
— configures a physical interface.
— configures a Loopback interface.
— configures a port channel.
— configures a VLAN.
— enables generation of internet control message protocol (ICMP)
Interfaces