Ip Tftp Source-Interface - Dell Z9500 Reference Manual

ip tftp source-interface

Assign an interface's IP address in outgoing packets for TFTP traffic.
Syntax
ip tftp source-interface interface
To return to the default setting, use the no ip tftp source-interface
interface command.
Parameters
interface
Defaults The IP address on the system that is closest to the Telnet address is used in the
outgoing packets.
Command CONFIGURATION
Modes
Command
This guide is platform-specific. For command information about other platforms,
History
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version
8.3.19.0
8.3.11.1
8.3.7.0
8.5.1.0
8.2.1.0
8.1.1.0
7.6.1.0
7.5.1.0
Control and Monitoring
Enter the following keywords and slot/port or number
information:
• For a 10-Gigabit Ethernet interface, enter the keyword
TenGigabitEthernet then the slot/port information.
• For a 40-Gigabit Ethernet interface, enter the keyword
fortyGigE then the slot/port information.
• For a Loopback interface, enter the keyword loopback
then a number from 0 to 16383.
• For a port channel interface, enter the keywords port-
channel then a number. The range is from 1 to 512.
• For a VLAN interface, enter the keyword vlan then a
number from 1 to 4094.
Description
Introduced on the S4820T.
Introduced on the Z9000.
Introduced on the S4820T.
Added support for 4-port 40G line cards on ExaScale.
Increased number of VLANs on ExaScale to 4094 (was
2094).
Introduced on the E-Series ExaScale.
Introduced on the S-Series.
Introduced on the C-Series.
115