Example
Dell# show hg-link-bundle-distribution slot 0 npuUnit 2 hg-
port-channel 0
hg-link-bundle trigger threshold - 60
Slot 0 npuUnit 2 hg-port-channel-0 Utilization [In Percent] -
0 Alarm State - Inactive
Interface Utilization [In Percent]
0/2:hg0
0/2:hg1
0/2:hg2
0/2:hg3
snmp-server enable traps hg-lbm
Enable the generation of SNMP traps and notifications when HiGig link-bundle monitoring is enabled.
Z9500
Syntax
snmp-server enable traps hg-lbm
Parameters
hg-lbm
Command
CONFIGURATION mode
Modes
Command
Version
History
9.2.1.0
9.3.0.0
UDP Broadcast
The user datagram protocol (UDP) broadcast feature is a software-based method to forward low
throughput (not to exceed 200 pps) IP/UDP broadcast traffic arriving on a physical or VLAN interface.
Important Points to Remember
•
Routing information protocol (RIP) is not supported with the UDP Broadcast feature.
•
If you configure this feature on an interface using the ip udp-helper udp-port command, the ip
directed-broadcast command becomes ineffective on that interface.
•
The existing show interface command has been modified to display the configured broadcast
address.
Interfaces
10
10
10
10
Enter the keyword hg-lbm to enable traps for HiGig link-
bundle monitoring.
Description
Introduced on the Z9500 switch.
Introduced on the Z9000 platform.
879