Dcb-Map Linecard All Backplane All; Dcb-Policy Buffer-Threshold Sfm All Port-Set All Backplane All - Dell Z9500 Reference Manual

dcb-map linecard all backplane all

Apply the specified DCB map on all ports of the switch linecard.
Syntax
dcb-map linecard <0-2/all> port-set <0-3/all> backplane all
<dcb-map-name>
To remove the PFC and ETS settings in a DCB map from all linecard units, use
theno dcb-map linecard <0-2/all> port-set <0-3/all>backplane
all <dcb-map-name> command.
Parameters
dcb-map-
name
Defaults None
Command CONFIGURATION
Modes
Command
Version
History
9.7(0.0)
Usage The dcb-map linecard all backplane all command overwrites any
Information
previous DCB maps applied to backplane
dcb-policy buffer-threshold sfm all port-set all backplane
all
Assign the DCB policy to all sfm and backplane ports interfaces. This setting takes precedence over the
global buffer-threshold interface configuration.
Syntax

dcb-policy buffer-threshold sfm all port-set all backplane all

<dcb-policy-name>
Parameters
buffer-
threshold
Defaults None.
Command GLOBAL CONFIGURATION
Modes
Command
This guide is platform-specific. For command information about other platforms,
History
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
600
Enter the name of the DCB map.
Description
Introduced on the Z9500.
Configure the profile name for the DCB buffer threshold
Data Center Bridging (DCB)