Send - Dell Z9500 Reference Manual

changes made to the nvram, such as stack-group and fanout configurations, must
be saved.

send

Send messages to one or all terminal line users.
Z9500
Syntax
send [*] | [line ] | [console] | [vty]
Parameters
*
line
console
vty
Defaults none
Command EXEC
Modes
Command
This guide is platform-specific. For command information about other platforms,
History
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version
9.2(1.0)
8.3.19.0
8.3.12.0
8.3.11.1
8.1.1.0
7.6.1.0
7.5.1.0
6.5.1.0
Usage Messages can contain an unlimited number of lines; however, each line is limited
Information to 255 characters. To move to the next line, use <CR>. To send the message use
CTR-Z; to abort a message, use CTR-C.
Control and Monitoring
Enter the asterisk character * to send a message to all tty
lines.
Send a message to a specific line. The range is from 0 to 11.
Enter the keyword console to send a message to the
primary terminal line.
Enter the keyword vty to send a message to the virtual
terminal.
Description
Introduced on the Z9500.
Introduced on the S4820T.
Introduced on the S4810.
Introduced on the Z9000.
Introduced on the E-Series ExaScale.
Introduced on the S-Series.
Introduced on the C-Series.
Introduced on the E-Series.
123