Neighbor Route-Reflector-Client - Dell Z9500 Reference Manual

Hide thumbs Also See for Z9500:

Table of Contents

When you apply a route map to outbound routes, only routes that match at least

one section of the route map are permitted.

If you identify a peer group by name, the peers in that peer group inherit the

characteristics in the Route map used in this command. If you identify a peer by IP

address, the Route map overwrites either the inbound or outbound policies on that

neighbor route-reflector-client

Configure the router as a route reflector and the specified neighbors as members of the cluster.

neighbor {ip-address | peer-group-name} route-reflector-client

To remove one or more neighbors from a cluster, use the no neighbor {ip-

address | peer-group-name} route-reflector-client command. If you

delete all members of a cluster, you also delete the route-reflector configuration

on the router.

Not configured.

This guide is platform-specific. For command information about other platforms,

refer to the relevant Dell Networking OS Command Line Reference Guide.

The following is a list of the Dell Networking OS version history for this command.

Enter the IP address of the neighbor in dotted decimal

Enter the name of the peer group.

All routers in the peer group receive routes from a route

Introduced on the Z9500.

Introduced on the S4820T.

Introduced on the Z9000.

Introduced on the S4810.

Introduced on the S-Series.

Introduced on the C-Series.

Border Gateway Protocol