Ip Control-Plane Egress-Filter; Show Ip Access-Lists - Dell Z9500 Reference Manual

•
Related
ip access-list standard
Commands
ip access-list extended

ip control-plane egress-filter

Enable egress Layer 3 ACL lookup for IPv4 CPU traffic.
Z9500
Syntax
ip control-plane egress-filter
Defaults Not enabled.
Command EXEC Privilege
Modes
Command
This guide is platform-specific. For command information about other platforms,
History
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version
9.2(1.0)
8.3.19.0
8.3.11.1
8.3.7.0

show ip access-lists

Display all of the IP ACLs configured in the system, whether or not they are applied to an interface, and
the count of matches/mismatches against each ACL entry displayed.
Syntax
show ip access-lists [access-list-name] [interface interface]
[in | out] [vrf vrf-name]
Parameters
access-list-
name
interface
interface
208
on a Layer 3 port or on a Layer 2/Layer 3 port
— configures a standard ACL.
— configures an extended ACL.
Description
Introduced on the Z9500.
Introduced on the S4820T.
Introduced on the Z9000.
Introduced on the S4810.
Enter the name of a configured MAC ACL, up to 140
characters.
Enter the keyword interface followed by the one of the
following keywords and slot/port or number information:
• For a VLAN interface, enter the keyword vlan followed
by the slot/port number.
• For a 1-Gigabit Ethernet interface, enter the keyword
GigabitEthernet followed by the slot/port
information.
Access Control Lists (ACL)