Dell Z9500 Reference Manual page 762

Hide thumbs Also See for Z9500:

Table of Contents

dead-interval

milliseconds

CONFIGURATION (conf-frrp)

This guide is platform-specific. For command information about other platforms,

refer to the relevant Dell Networking OS Command Line Reference Guide.

The following is a list of the Dell Networking OS version history for this command.

The hello interval command is the interval at which ring frames are generated

from the primary interface of the master node. The dead interval command is

the time that elapses before a time-out occurs.

invalid value is entered, an error message is generated. The

range is from 50 to 2000 ms. Default: 500 ms.

Enter the keyword dead-interval then the time, in

milliseconds, to set the dead interval of the control packets.

The range is from 50 to 6000 ms. Default: 1500 ms.

500 ms for hello-interval milliseconds

1500 ms for dead-intervalmilliseconds

Introduced on the Z9500.

Introduced on the S4820T.

Introduced on the Z9000.

Introduced on the S4810.

Introduced on the C-Series.

NOTE: The configured dead interval must be at least

three times the hello interval.

Force10 Resilient Ring Protocol (FRRP)