Show Ip Bgp - Dell Z9500 Reference Manual

Command ROUTER BGP
Modes
Command
This guide is platform-specific. For command information about other platforms,
History
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version
9.2(1.0)
8.3.19.0
8.3.11.1
8.3.7.0
7.8.1.0
7.7.1.0
Example
Dell(conf-router_bgp)#show config
!
router bgp 45
neighbor suzanne peer-group
neighbor suzanne no shutdown
neighbor sara peer-group
neighbor sara shutdown
neighbor 13.14.15.20 peer-group suzanne
neighbor 13.14.15.20 shutdown
neighbor 123.34.55.123 peer-group suzanne
neighbor 123.34.55.123 shutdown
Dell(conf-router_bgp)#
Related capture bgp-pdu max-buffer-size
Commands

show ip bgp

View the current BGP IPv4 routing table for the system.
Z9500
Syntax
show ip bgp [vrf vrf-name] [ipv4 unicast] [network [network-
mask] [longer-prefixes]]
Parameters
vrf vrf-name
ipv4 unicast
network
Border Gateway Protocol
Description
Introduced on the Z9500.
Introduced on the S4820T.
Introduced on the Z9000.
Introduced on the S4810.
Introduced on the S-Series.
Introduced on the C-Series.
— specifies a size for the capture buffer.
(OPTIONAL) Enter the keyword vrf and then the name of
the VRF to view ipv4–unicast route information
corresponding to that VRF.
(OPTIONAL) Enter the keywords ipv4 unicast to view
information only related to ipv4 unicast routes.
(OPTIONAL) Enter the network address (in dotted decimal
format) of the BGP network to view information only on that
network.
423