Ip Telnet Server Enable; Ip Telnet Source-Interface - Dell Z9500 Reference Manual

ip telnet server enable

Enable the Telnet server on the switch.
Z9500
Syntax
ip telnet server enable
To disable the Telnet server, use the no ip telnet server enable command.
Defaults Enabled
Command CONFIGURATION
Modes
Command
This guide is platform-specific. For command information about other platforms,
History
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version
9.2(1.0)
8.3.11.1
8.1.1.0
7.6.1.0
7.5.1.0
6.1.1.0
Related ip ssh server
Commands

ip telnet source-interface

Set an interface's IP address as the source address in outgoing packets for Telnet sessions.
Syntax
ip telnet source-interface interface
To return to the default setting, use the no ip telnet source-interface
[interface] command.
Parameters
interface
Control and Monitoring
Description
Introduced on the Z9500.
Introduced on the Z9000.
Introduced on the E-Series ExaScale.
Introduced on the S-Series.
Introduced on the C-Series.
Introduced on the E-Series.
— enables the secure shell (SSH) server on the system.
Enter the following keywords and slot/port or number
information:
• For a 10-Gigabit Ethernet interface, enter the keyword
TenGigabitEthernet then the slot/port information.
• For a 40-Gigabit Ethernet interface, enter the keyword
fortyGigE then the slot/port information.
113