Proceed with reload [confirm yes/no]: n
Dell(conf-if-te-5/0)#
enable
Enter EXEC Privilege mode or any other privilege level configured. After entering this command, you may
need to enter a password.
Z9500
Syntax
enable [level]
Parameters
level
Defaults
15
Command
EXEC
Modes
Command
This guide is platform-specific. For command information about other platforms,
History
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version
9.5(0.1)
9.5(0.0)
9.2(1.0)
9.0.2.0
8.3.19.0
8.3.12.0
8.3.11.1
8.1.1.0
7.6.1.0
7.5.1.0
E-Series
Usage
Users entering EXEC Privilege mode or any other configured privilege level can
Information
access configuration commands. To protect against unauthorized access, use the
enable password command to configure a password for the enable command
100
(OPTIONAL) Enter a number for a privilege level of Dell
Networking OS. The range is from 0 to 15.
Description
Added support for roles on the Z9500.
Added support for roles on the Z9000, S6000, S4820T,
S4810, MXL
Introduced on the Z9500.
Introduced on the S6000.
Introduced on the S4820T.
Introduced on the S4810.
Introduced on the Z9000.
Introduced on the E-Series ExaScale.
Introduced on the S-Series.
Introduced on the C-Series.
Original command.
Control and Monitoring