Neighbor Add-Path - Dell Z9500 Reference Manual

Defaults Disabled
Command CONFIGURATION-ROUTER-BGP-ADDRESS FAMILY
Modes
Command
This guide is platform-specific. For command information about other platforms,
History
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version
9.2(1.0)
8.3.19.0
8.3.11.1
8.3.7.0
7.8.1.0
7.7.1.0
Usage By default, when you create a neighbor/peer group configuration in the Router
Information BGP context, this enables IPv4/Unicast AFI/SAFI. When you use activate in the
new context, the neighbor/peer group enables for AFI/SAFI.

neighbor add-path

This command allows the specified neighbor/peer group to send/receive multiple path advertisements.
Z9500
Syntax
neighbor [ip-address | peer-group-name] add-path [send |
receive | both] path-count
Parameters
ip-address
peer-group-
name
send
receive
both
path-count
Defaults none
384
Description
Introduced on the Z9500.
Introduced on the S4820T.
Introduced on the Z9000.
Introduced on the S4810.
Introduced on the S-Series.
Introduced on the C-Series.
(OPTIONAL) Enter the IP address of the neighbor in dotted
decimal format.
(OPTIONAL) Enter the name of the peer group.
Enter the keyword send to indicate that the system sends
multiple paths to peers.
Enter the keyword receive to indicate that the system
accepts multiple paths from peers.
Enter the keyword both to indicate that the system sends
and accepts multiple paths from peers.
Enter the number paths supported. The range is from 2 to
64.
Border Gateway Protocol