Ipv4 Unicast-Host-Route - Dell Z9500 Reference Manual

Version
6.1.1.0

ipv4 unicast-host-route

Enable the storage of IPv4 route prefixes in the L3 host table.
Z9500
Syntax
[no] ipv4 unicast-host-route
Defaults Disabled; by default, all IPv4 route prefixes are stored installed only in the Longest
Prefix Match (LPM) table.
Command CONFIGURATION
Modes
Command
Version
History
9.5(0.1)
9.3(0.1)
Usage
Route prefixes stored in the L3 host table are managed using ECMP next-hop
Information
forwarding.
A warning message is displayed after you enter the command stating that this
setting takes effect for existing routes only when IPv4 route prefixes are cleared
from the LPM routing table (RTM). To enable storage of IPv4 route prefixes in the
LPM table, disable this setting by entering the no ipv4 unicast-host-route
command.
Example
Dell(conf)#ipv4 unicast-host-route
Warning: Command will take effect for existing routes only
when IPv4
route prefixes are cleared from RTM
Dell(conf)#no ipv4 unicast-host-route
IPv4 Routing
Description
Introduced on the E-Series.
Description
Introduced on the Z9500.
Introduced on the S6000.
925