Ip Http Source-Interface - Dell Z9500 Reference Manual

ip http source-interface

Configure an interface's IP address as the source IP address for HTTP connections.
Syntax
ip http source-interface interface
To delete an interface, use theno ip http source-interface interface
command.
Parameters
interface
Defaults The IP address on the system that is closest to the Telnet address is used in the
outgoing packets.
Command CONFIGURATION
Modes
Command
Version
History
9.5(0.1)
9.3(0.1)
8.3.11.1
8.2.1.0
8.1.1.0
7.6.1.0
7.5.1.0
112
Enter the following keywords and slot/port or number
information:
• For Loopback interfaces, enter the keyword loopback
then a number from zero (0) to 16383.
• For a Port Channel interface, enter the keyword port-
channel then a number. The range is from 1 to 512.
• For a 10-Gigabit Ethernet interface, enter the keyword
TenGigabitEthernet then the slot/port information.
• For a 40-Gigabit Ethernet interface, enter the keyword
fortyGigE then the slot/port information.
• For a VLAN interface, enter the keyword vlan then a
number from 1 to 4094.
• For a tunnel interface, enter the keyword tunnel.
Description
Introduced on the Z9500.
Introduced on the S4810, S4820T, S6000, and Z9000.
Introduced on the Z9000
Increased number of VLANs on ExaScale to 4094 (was
2094)
Introduced on E-Series ExaScale
Support added for S-Series
Introduced on C-Series
Control and Monitoring