Ip Access-List Extended - Dell Z9500 Reference Manual

ip access-list extended

Configure an extended IP access list (IP ACL) based on IP addresses or protocols.
Z9500
Syntax
ip access-list extended access-list-name [cpu-qos]
To delete an access list, use the no ip access-list extended access-
list-name [cpu-qos] command.
Parameters
access-list-
name
cpu-qos
Defaults All access lists contain an implicit "deny any"; that is, if no match occurs, the packet
is dropped.
Command CONFIGURATION
Modes
Command
This guide is platform-specific. For command information about other platforms,
History
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version
9.2(1.0)
8.3.19.0
8.3.11.1
8.3.10.0
8.1.1.0
7.8.1.0
7.6.1.0
7.5.1.0
6.2.1.1
Usage
The number of entries allowed per ACL is hardware-dependent. For detailed
Information
information on the number entries allowed per ACL on the Z9500, refer to the
Content Addressable Memory (CAM) chapter in the Z9500 Configuration Guide.
Access Control Lists (ACL)
Enter a string up to 140 characters long as the access list
name.
Enter the keyword cpu-qos to configure an extended IP ACL
to be used only to filter protocol traffic for control-plane
policing (CoPP).
Description
Introduced on the Z9500.
Introduced on the S4820T.
Introduced on the Z9000.
Introduced on the S4810.
Introduced on the E-Series ExaScale.
Increased the name string to accept up to 140 characters.
Prior to 7.8.1.0, names were up to 16 characters long.
Introduced on the S-Series.
Introduced on the C-Series.
Introduced on the E-Series.
235