Standard Mac Acl Commands - Dell Z9500 Reference Manual

Command
This guide is platform-specific. For command information about other platforms,
History
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version
9.7(0.0)
9.0.2.0
8.3.19.0
8.3.11.1
8.3.7.0
8.5.1.0
8.1.1.0
7.8.1.0
7.6.1.0
7.5.1.0
6.1.1.0
Usage The ACL hit counters increment the counters for each matching rule, not just the
Information first matching rule.
Example
Dell#show mac accounting access-list TestMac interface
tengigabitethernet 1/8 in
Ingress Standard mac access-list TestMac on TenGigabitEthernet
1/89
Total cam count 2
seq 5 permit aa:aa:aa:aa:00:00 00:00:00:00:ff:ff count (0
packets)
seq 10 deny any count (20072594 packets)
Dell#

Standard MAC ACL Commands

When you create an access control list without any rule and then apply it to an interface, the ACL
behavior reflects implicit permit. These commands configure standard MAC ACLs.
The Z9500 support both Ingress and Egress MAC ACLs.
NOTE: For more information, also refer to the
MAC Access List Commands
266
Description
Introduced on the S6000–ON.
Introduced on the S6000.
Introduced on the S4820T.
Introduced on the Z9000.
Introduced on the S4810.
Added support for 4-port 40G line cards on ExaScale.
Introduced on the E-Series ExaScale.
Increased the name string to accept up to 140 characters.
Prior to 7.8.1.0, names are up to 16 characters long.
Introduced on the S-Series.
Introduced on the C-Series
Introduced on the E-Series.
Commands Common to all ACL Types
sections.
and Common
Access Control Lists (ACL)