Hg-Link-Bundle-Monitor Trigger-Threshold; Show Hardware Hg-Stats - Dell Z9500 Reference Manual

Usage The rate interval used to poll member links is globally configured and applied to all
Information HiGig link bundles in the system.

hg-link-bundle-monitor trigger-threshold

Specify the bandwidth-percentage threshold used in HiGig link-bundle monitoring to determine uneven
traffic distribution and when an alarm is generated.
Z9500
Syntax
hg-link-bundle-monitor trigger-threshold percentage
To restore the default value, use the no version of this command.
Parameters
percentage
Command CONFIGURATION
Modes
Command
Version
History
9.2.1.0
9.3.0.0
Defaults The default trigger-threshold value is 60.
Usage The trigger-threshold of bandwidth usage, which determines when the calculation
Information of link-bundle utilization is performed, is set at 60 percent of the link-bundle
bandwidth. When the total traffic use (mean) is below the trigger-threshold
percentage, unevenness in link-bundle traffic distribution is not reported. If traffic
unevenness is detected in three consecutive measurements, an alarm is issued. The
time interval between measurements is defined by the rate interval for HiGig link
polling (default 15 seconds).

show hardware hg-stats

Display the traffic statistics from internal ports in a HiGig link bundle/port channel on a line-card or
switch fabric module (SFM) NPU.
Z9500
Syntax
show hardware {sfm npu-id | linecard slot} hg-stats {port hg-
port—number | unit npu-id port hg-port—number}
Parameters
sfm npu-id
linecard slot
Interfaces
Trigger threshold (in percentage of link-bundle bandwidth)
at which an SNMP trap is generated. Valid values are 1 to 90.
Description
Introduced on the Z9500 switch.
Introduced on the Z9000 platform.
Specify a Z9500 SFM (spine) NPU by entering the keyword
sfm and SFM NPU ID. Valid SFM NPU IDs are 0 to 5.
Specify a Z9500 line-card (leaf) NPU by entering the
keyword linecard and line-card slot. Valid slot numbers
are 0 to 2.
875