show hosts
View the host table and DNS configuration.
Z9500
Syntax
show hosts
Command
•
Modes
•
Command
This guide is platform-specific. For command information about other platforms,
History
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version
9.2(1.0)
9.0.0.0
8.3.19.0
8.3.11.1
8.1.1.0
7.6.1.0
7.5.1.0
6.1.1.0
Usage
The following describes the show hosts command in the following example.
Information
Field
Default domain...
Name/address
lookup...
Name servers
are...
Host
Flags
IPv4 Routing
EXEC
EXEC Privilege
Description
Introduced on the Z9500.
Added support for IPv6 addresses.
Introduced on the S4820T.
Introduced on the Z9000.
Introduced on the E-Series ExaScale.
Introduced on the S-Series.
Introduced on the C-Series.
Introduced on the E-Series.
Description
Displays the domain name (if configured).
States if DNS is enabled on the system.
•
If DNS is enabled, the Name/Address lookup is domain
service.
•
If DNS is not enabled, the Name/Address lookup is static
mapping
Lists the name servers, if configured.
Displays the host name assigned to the IP address.
Classifies the entry as one of the following:
•
perm — the entry was manually configured and will not
time out
933