Dell Z9500 Reference Manual page 928

To remove a static route, use the no management route{{ip-address mask
| {ipv6-address prefix-length}}{forwarding-router-address |
managementethernet} command.
Parameters
ip-address
mask
ipv6-address
prefix-length
forwarding-
router-address
managementet
hernet
Defaults Not configured.
Command CONFIGURATION
Modes
Command
This guide is platform-specific. For command information about other platforms,
History
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version
9.2(1.0)
9.0.0.0
8.3.19.0
8.3.11.1
8.1.1.0
7.5.1.0
6.1.1.0
Usage When a static route (or a protocol route) overlaps with Management static route,
Information the static route (or a protocol route) is preferred over the Management Static route.
Also, Management static routes and the Management Connected prefix are not
reflected in the hardware routing tables. Separate routing tables are maintained for
IPv4 and IPv6 management routes. This command manages both tables.
928
Enter an IP address (dotted decimal format) and mask (/prefix
format) of the destination subnet.
Enter an IPv6 address (x:x:x:x::x format) and mask (/prefix
format) of the destination subnet. Enter the IPv6 address in
the x:x:x:x::x format followed by the prefix length in the /x
format.
The range is from /0 to /128.
NOTE: The :: notation specifies successive hexadecimal
fields of zeros.
Enter an IP address (dotted decimal format) or an IPv6
address (x:x:x:x::x format) of a forwarding router.
Enter the keyword managementethernet for the
Management interface on the Primary RPM.
Description
Introduced on the Z9500.
Introduced on the Z9000 and added support for IPv6.
Introduced on the S4820T.
Introduced on the S4810.
Introduced on the E-Series ExaScale.
Introduced on the C-Series.
Introduced on the E-Series.
IPv4 Routing