Dell Z9500 Reference Manual page 173

ip-address
ipv6-address
Defaults
•
•
•
•
•
Command
•
Modes
•
Command
This guide is platform-specific. For command information about other platforms,
History
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version
9.2(1.0)
8.3.19.0
8.3.12.0
8.3.11.1
8.2.1.0
8.1.1.0
7.9.1.0
7.6.1.0
7.5.1.0
7.4.1.0
E-Series
Usage When you enter the traceroute command without specifying an IP address
Information (Extended Traceroute), you are prompted for a target and source IP address,
timeout (in seconds) (default is 5), a probe count (default is 3), minimum TTL
(default is 1), maximum TTL (default is 30), and port number (default is 33434). To
keep the default setting for those parameters, press the ENTER key.
For IPv6, you are prompted for a minimum hop count (default is 1) and a maximum
hop count (default is 64).
Control and Monitoring
Enter the IP address of the device in dotted decimal format.
Enter the IPv6 address, in the x:x:x:x::x format, to which you
are testing connectivity.
Timeout = 5 seconds
Probe count = 3
30 hops max
40 byte packet size
UDP port = 33434
EXEC
EXEC Privilege
Description
Introduced on the Z9500.
Introduced on the S4820T.
Introduced on the S4810.
Introduced on the Z9000.
Introduced on the E-Series ExaScale with IPv6.
Introduced on the E-Series ExaScale (IPv4 only).
Introduced VRF.
Added support for the S-Series.
Introduced on the C-Series.
Added support for IPv6 address on the E-Series.
Original command.
NOTE: The :: notation specifies successive hexadecimal
fields of zeros.
173