Show Config; Show Config (From Interface Range Mode) - Dell Z9500 Reference Manual

9
10
11
Related
•
Commands

show config

Display the interface configuration.
Z9500
Syntax
show config
Command INTERFACE
Modes
Command
This guide is platform-specific. For command information about other platforms,
History
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version
9.2(1.0)
8.3.19.0
8.3.11.1
8.3.7.0
8.1.1.0
7.6.1.0
7.5.1.0
6.2.1.0
Example
Dell(conf-if)#show conf
!
interface TenGigabitEthernet 1/7
Dell(conf-if)#

show config (from INTERFACE RANGE mode)

Display the bulk configured interfaces (interface range).
Z9500
Syntax
show config
834
Member not present
Member not present
Member not present
reload – reboots the Dell Networking OS.
Description
Introduced on the Z9500.
Introduced on the S4820T.
Introduced on the Z9000.
Introduced on the S4810.
Introduced on the E-Series ExaScale.
Introduced on the S-Series.
Introduced on the C-Series.
Introduced on the E-Series.
no ip address
switchport
no shutdown
Interfaces