Clear Arp-Cache - Dell Z9500 Reference Manual

Defaults 240 minutes (4 hours)
Command INTERFACE
Modes
Command
This guide is platform-specific. For command information about other platforms,
History
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version
9.2(1.0)
8.3.19.0
8.3.11.1
8.3.7.0
8.1.1.0
7.6.1.0
7.5.1.0
6.2.1.1
Related show interfaces
Commands

clear arp-cache

Clear the dynamic ARP entries from a specific interface or optionally delete (no-refresh) ARP entries
from the content addressable memory (CAM).
Z9500
Syntax
clear arp-cache [vrf vrf-name | interface | ip ip-address] [no-
refresh]
Parameters
vrf vrf-name
interface
896
Description
Introduced on the Z9500.
Introduced on the S4820T.
Introduced on the Z9000.
Introduced on the S4810.
Introduced on the E-Series ExaScale.
Introduced on the S-Series.
Introduced on the C-Series.
Introduced on the E-Series.
— displays the ARP timeout value for all available interfaces.
(OPTIONAL) Enter the keyword vrf and then the name of
the VRF to clear the ARP cache corresponding to that VRF.
(OPTIONAL) Enter the following keywords and slot/port or
number information:
• For a 10-Gigabit Ethernet interface, enter the keyword
TenGigabitEthernet then the slot/port information.
• For a 40-Gigabit Ethernet interface, enter the keyword
fortyGigE then the slot/port information.
• For the Management interface on the stack-unit, enter
the keyword ManagementEthernet then the slot/port
IPv4 Routing