Flex Hash; Load-Balance Ingress-Port Enable - Dell Z9500 Reference Manual

Flex Hash

This chapter describes the Flex Hash enhancements.

load-balance ingress-port enable

Enable the Flex hash feature.
Z9500
Syntax
load-balance ingress-port enable
To disable the Flex hash capability, use the no version of this command.
Default None
Command CONFIGURATION mode
Modes
Command
Version 9.2.1.0
History
Version 9.3.0.0
Usage Flex hash uses the RTAG7 bins 2 and 3 (overlay bins). These bins must be enabled
Information for Flex hash to be configured. These bins contain the source module and source
port information. These bins are disabled by default in releases of Dell Networking
OS earlier than Release 9.3.0.0. The default behavior of disabling of these bins
occurs because of incorrect egress port information that would otherwise be
displayed in the output of the diagnostic show ip flow command.
When you enable the load balancing of RRoCE packets using Flex hash, the show
ip flow command is disabled. Similarly, when the show ip flow command is
enabled (ingress port based load balancing is disabled), the hashing of RRoCE
packets is disabled.
Flex hash APIs do not mask out unwanted byte values after extraction of the data
from the Layer 4 headers for the offset value.
Example
Dell(conf)#load-balance ingress-port enable
726
Introduced on the Z9500 switch.
Introduced on the S6000 platform
15
Flex Hash