Ipv6 Helper-Address - Dell Z9500 Reference Manual

Defaults Disabled
Command
INTERFACE
Modes
INTERFACE PORTCHANNEL
Command
This guide is platform-specific. For command information about other platforms,
History
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version 9.6(0.0)
Version 9.0.2.0
Version
8.3.19.0
Version 8.3.11.1
Version 8.3.7.0
Version 8.3.1.0
Version 8.2.1.0
Version 7.8.1.0
Usage
Allocate at least one FP block to ipmacacl before you can enable IP+MAC Source
Information
Address Validation and SAV with VLAN option.
1.
2.
3.

ipv6 helper-address

Configures the ipv6 DHCP helper addresses without VRF.
Syntax
[no] ipv6 helper-address ipv6-address
To delete the ipv6 helper address, use the [no] ipv6 helper-address ipv6-
address command.
Parameters
ipv6-address
Default Disabled.
Command INTERFACE
Modes
Dynamic Host Configuration Protocol (DHCP)
Added the keyword vlan and the variable vlan-id.
Introduced support for SAV on port channels.
Introduced on the S6000.
Introduced on the S4820T.
Introduced on the Z9000.
Introduced on the S4810.
Introduced on the E-Series.
Added the keyword ipmac.
Introduced on the C-Series and S-Series.
Use the cam-acl l2acl command from CONFIGURATION mode.
Save the running-config to the startup-config.
Reload the system.
Enter the keywordipv6–address through which the server
address can be reached.
707