Neighbor Send-Community - Dell Z9500 Reference Manual

Hide thumbs Also See for Z9500:

Table of Contents

A route reflector reflects routes to the neighbors assigned to the cluster. Neighbors

in the cluster do not need not to be fully meshed. By default, when you use no

route reflector, the internal BGP (IBGP) speakers in the network must be fully

The first time you enter this command, the router configures as a route reflector

and the specified BGP neighbors configure as clients in the route-reflector cluster.

When you remove all clients of a route reflector using the no neighbor route-

reflector-client command, the router no longer functions as a route

If the clients of a route reflector are fully meshed, you can configure the route

reflector to not reflect routes to specified clients by using the no bgp client-

to-client reflection command.

bgp client-to-client reflection

reflector and the clients.

neighbor send-community

Send a COMMUNITY attribute to a BGP neighbor or peer group. A COMMUNITY attribute indicates that

all routes with that attribute belong to the same community grouping.

neighbor {ip-address | peer-group-name} send-community

To disable sending a COMMUNITY attribute, use the no neighbor {ip-address

| peer-group-name} send-community command.

Not configured and COMMUNITY attributes are not sent to neighbors.

This guide is platform-specific. For command information about other platforms,

refer to the relevant Dell Networking OS Command Line Reference Guide.

The following is a list of the Dell Networking OS version history for this command.

Border Gateway Protocol

— enables route reflection between the route

Enter the IP address of the peer router in dotted decimal

Enter the name of the peer group to send a COMMUNITY

attribute to all routers within the peer group.

Optional. Enter the keyword extended to send extended

community attribute.

Optional. Enter the keyword standard to send standard

community attribute.