group-address
interface
interface
Defaults
Disabled.
Command
EXEC Privilege
Modes
Command
This guide is platform-specific. For command information about other platforms,
History
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version
9.7(0.0)
Usage
IGMP commands accept only non-VLAN interfaces — specifying VLAN does not
Information
yield results. This command displays packets for IGMP and IGMP snooping.
ip igmp snooping enable
Enable IGMP snooping on all or a single VLAN. This command is the master on/off switch to enable IGMP
snooping.
Syntax
ip igmp snooping enable
To disable IGMP snooping, use the no ip igmp snooping enable command.
Defaults
Disabled.
Command
•
Modes
•
Command
This guide is platform-specific. For command information about other platforms,
History
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
794
(OPTIONAL) Enter the IP multicast group address in dotted
decimal format.
Enter the following keywords and slot/port or number
information:
•
For a 10-Gigabit Ethernet interface, enter the keyword
TenGigabitEthernet then the slot/port information.
•
For a 40-Gigabit Ethernet interface, enter the keyword
fortyGigE then the slot/port information.
•
For a port channel interface, enter the keywords port-
channel then a number.
Description
Introduced on the S4810, S4820T, S5000, S6000, S6000–
ON, Z9000, and Z9500.
CONFIGURATION
INTERFACE VLAN
Internet Group Management Protocol (IGMP)