Dell Z9500 Reference Manual page 907

Hide thumbs Also See for Z9500:

Table of Contents

EXEC Privilege

This guide is platform-specific. For command information about other platforms,

refer to the relevant Dell Networking OS Command Line Reference Guide.

The following is a list of the Dell Networking OS version history for this command.

The following describes the debug ip packet command in the following

sending, rcvd,

fragment, sending

broad/multicast

proto, unroutable

IPv4 Routing

For a port channel interface, enter the keywords port-

channel then a number. The range is from 1 to 512.

For a VLAN interface, enter the keyword vlan then a

number from 1 to 4094.

Introduced on the S6000-ON.

Introduced on the S6000.

Introduced on the S4820T.

Introduced on the Z9000.

Added support for 4-port 40G line cards on ExaScale.

Introduced on the S4810.

Added support for 4094 VLANs on the E-Series ExaScale

(the prior limit was 2094).

Introduced on the E-Series ExaScale.

Added the access-group option.

Introduced on the S-Series.

Introduced on the C-Series.

Added the count option.

Lists the source address of the packet and the name of the

interface (in parentheses) that received the packet.

Lists the destination address of the packet and the name of

the interface (in parentheses) through which the packet is

being sent out on the network.

Displays the packet's length.

The last part of each line lists the status of the packet.