Flowcontrol - Dell Z9500 Reference Manual

full
Defaults Not configured.
Command INTERFACE
Modes
Command
This guide is platform-specific. For command information about other platforms,
History
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version
9.2(1.0)
8.3.11.1
8.1.1.0
7.5.1.0
7.4.1.0
Usage This command applies only to the Management interface on the route processor
Information modules (RPMs).
Related
interface ManagementEthernet
Commands
(either the Primary or Standby RPM).
duplex (Management)
management route
interface or a forwarding router.
speed (Management interface)

flowcontrol

Enable and disable link-level flow control (802.3x pause frames) on an interface and (optionally)
configure buffer thresholds for pause and offset frame transmission.
Z9500
Syntax
flowcontrol rx {off | on} tx {off | on} [pause-threshold
{1-12480}] [resume-offset {1-12480}]
Parameters
rx on
rx off
Interfaces
Enter the keyword full to set the Management interface to
transmit in both directions.
Description
Introduced on the Z9500.
Introduced on the Z9000.
Introduced on the E-Series ExaScale.
Introduced on the C-Series.
Documentation modified—added Management to
distinguish from duplex (10/100 Interfaces).
— configures the Management port on the system
— sets the mode of the Management interface.
— configures a static route that points to the Management
— sets the speed on the Management interface.
Enter the keywords rx on to process the received flow
control frames on this port.
Enter the keywords rx off to ignore the received flow
control frames on this port.
809