Clear Ip Dhcp Snooping - Dell Z9500 Reference Manual

Command
This guide is platform-specific. For command information about other platforms,
History
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version
9.2(1.0)
8.3.19.0
8.3.11.1
8.3.7.0
8.3.1.0
8.2.1.0
Related arp inspection
Commands

clear ip dhcp snooping

Clear the DHCP binding table.
Syntax
clear ip dhcp snooping {binding | source-address-validation
discard-counters [interface interface]}
Parameters
binding
source-
address-
validation
discard-
counters
interface
interface
Defaults none
696
Description
Introduced on the Z9500.
Introduced on the S4820T.
Introduced on the Z9000.
Introduced on the S4810.
Introduced on the E-Series.
Introduced on the C-Series and S-Series.
— enables dynamic ARP inspection on a VLAN.
Clears the binding table.
Clears discard counters from all the interfaces configured
with IP Source Guard.
(OPTIONAL) Specifies an interface to clear the discard
counters.
Enter any of the following keywords and slot/port or number
information:
• For a 10-Gigabit Ethernet interface, enter the keyword
TenGigabitEthernet then the slot/port information.
• For a 40-Gigabit Ethernet interface, enter the keyword
fortyGigE then the slot/port information.
• For a port channel interface, enter the keywords port-
channel then a number. The range is from 1 to 512.
Dynamic Host Configuration Protocol (DHCP)