Dell Z9500 Reference Manual page 614

%Info: Data for instance id id is not available.
For example, if you configured 5 as the maximum instances with linear periodicity
and a polling interval of 10 seconds, 1 as the multiplier, then 5 instances will be
polled at 10, 20, 30, 40, and 50 seconds incrementally. If you attempt to enter the
show command to display the fifth instance after 30 seconds of enabling polling,
the aforementioned information message is shown.
If specified instance ID is higher than the size of the maximum number of snapshot
instances configured, the following error message is displayed on the console:
%Error: Instance Id is not valid. Configured max snapshot
instances are <max-instances>
If you configured the maximum number of instances as 5 and attempt to view the
buffer statistics tracking details for the instance ID of 6, the aforementioned error is
shown.
Example
Dell#show hardware linecard 0 buffer-stats-snapshot unit 0
resource port 5 queue all history summary
linecard 0 unit 0 port 5 (interface te 0/4)
---------------------------------------------------------------
------------------------------------------------
Q# TYPE
Instance 3 Instance 4 Instance 5
30S
---------------------------------------------------------------
------------------------------------------------
UCAST
6
UCAST
1
UCAST
2
MCAST
0
If only two instances are available at the time the above show command is issued,
only two instances will be displayed in the summary output.
---------------------------------------------------------------
------------------------------------------------
Q# TYPE
---------------------------------------------------------------
------------------------------------------------
UCAST
1
UCAST
UCAST
MCAST
Dell#show hardware linecard 0 buffer-stats-snapshot unit 0
614
Q#
40S 50S
2 5
0
3 2
5
11 0
0
4 0
0
Q#
2 5
3 2
11 0
4 0
TOTAL BUFFERED CELLS
Instance 1 Instance 2
10S 20S
4
1
0
0
3
3
0
3
TOTAL BUFFERED CELLS
Instance 1 Instance 2
10S 20S
4
0
3
0
Data Center Bridging (DCB)