Clear Ip Route - Dell Z9500 Reference Manual

Hide thumbs Also See for Z9500:

Table of Contents

This guide is platform-specific. For command information about other platforms,

refer to the relevant Dell Networking OS Command Line Reference Guide.

The following is a list of the Dell Networking OS version history for this command.

To clear Layer 3 CAM inconsistencies, use this command.

show ip fib linecard

clear ip route

Clear one or all routes in the routing table.

clear ip route {* | ip-address mask}

EXEC Privilege

This guide is platform-specific. For command information about other platforms,

refer to the relevant Dell Networking OS Command Line Reference Guide.

The following is a list of the Dell Networking OS version history for this command.

IPv4 Routing

Introduced on the Z9500.

Introduced on the Z9000.

Introduced on the S4810.

Introduced on the S4820T.

CAUTION: Executing this command causes traffic disruption.

— shows FIB entries on a specified stack-unit.

Enter an asterisk (*) to clear all learned IP routes.

Enter a specific IP address and mask in dotted decimal

format to clear that IP address from the routing table.

Introduced on the Z9500.

Introduced on the S4820T.

Introduced on the Z9000.

Introduced on the S4810.