Link-Bundle-Distribution Trigger-Threshold - Dell Z9500 Reference Manual

Hide thumbs Also See for Z9500:

Table of Contents

To negate a command, use the no ip ecmp-group maximum-paths {number}

path-fallback

CONFIGURATION

You must save the new ECMP settings to the startup-config (write-mem) then

reload the system for the new settings to take effect.

show ip cam linecard

set of ports on a line card.

link-bundle-distribution trigger-threshold

Provides a mechanism to set the threshold to trigger when traffic distribution begins being monitored on

an ECMP link bundle.

link-bundle-distribution trigger-threshold [percent]

To exit from ecmp group mode, use the exit command.

EXEC Privilege

This guide is platform-specific. For command information about other platforms,

refer to the relevant Dell Networking OS Command Line Reference Guide.

Specify the maximum number of ECMP for a route. The

range is 2 to 64.

Use the keywords path-fallback to enable this feature. If

you enable the feature, re-enter this keyword to disable the

Introduced on the Z9500.

Introduced on the Z9000.

Introduced on the S4810.

– Display content-addressable memory (CAM) entries for a

Indicate the threshold value when traffic distribution starts

being monitored on an ECMP link bundle. The range is from

1 to 90%. The default is 60%.

Equal Cost Multi-Path (ECMP)