Arp Backoff-Time - Dell Z9500 Reference Manual

The following is a list of the Dell Networking OS version history for this command.
Version
9.7(0.0)
9.4(0.0)
9.0.2.0
8.3.19.0
8.3.11.1
8.5.1.0
8.3.7.0
8.1.1.0
7.6.1.0
7.5.1.0
pre-6.2.1.0
Usage You cannot use Class D or Class E IP addresses or zero IP address (0.0.0.0) when
Information creating a static ARP. Zero MAC addresses (00:00:00:00:00:00) are also invalid.
Related
clear arp-cache
Commands
show arp

arp backoff-time

Set the exponential timer for resending unresolved ARPs.
Z9500
Syntax
arp backoff-time seconds
Parameters
seconds
Defaults 30
Command CONFIGURATION
Mode
Command
This guide is platform-specific. For command information about other platforms,
History
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
IPv4 Routing
Description
Introduced on the S6000-ON.
Added support for VRF.
Introduced on the S6000.
Introduced on the S4820T.
Introduced on the Z9000.
Added support for 4-port 40G line cards on ExaScale.
Introduced on the S4810.
Introduced on the E-Series ExaScale.
Introduced on the S-Series.
Introduced on the C-Series.
Introduced on the E-Series.
— clears dynamic ARP entries from the ARP table.
— displays the ARP table.
Enter the number of seconds an ARP entry is black-holed.
The range is from 1 to 3600. The default is 30.
893