Dell Z9500 Reference Manual page 846

Version
8.3.19.0
8.3.11.1
8.3.7.0
8.1.1.0
7.6.1.0
6.5.4.0
Usage The following describes the show interfaces tengigabitethernet
Information
command following example.
Mode Control
Mode Status
AutoNegotiatio
n Advertise
AutoNegotiatio
n Remote
Partner's Ability
AutoNegotiatio
n Expansion
1000Base-T
Control
Phy Specific
Control
846
Description
Introduced on the S4820T.
Introduced on the Z9000.
Introduced on the S4810.
Introduced on the E-Series ExaScale.
Introduced on the C-Series and S-Series.
Introduced on the E-Series.
Indicates if auto negotiation is enabled. If so, indicates
the selected speed and duplex.
Displays auto negotiation fault information. When the
interface completes auto negotiation successfully, the
autoNegComplete field and the linkstatus field read
"True."
Displays the control words the local interface advertises
during negotiation. Duplex is either half or full. Asym- and
Sym Pause is the types of flow control the local interface
supports.
Displays the control words the remote interface advertises
during negotiation. Duplex is either half or full. Asym- and
Sym Pause is the types of flow control the remote interface
supports.
ParallelDetectionFault is the handshaking scheme in which
the link partner continuously transmit an "idle" data packet
using the Fast Ethernet MLT-3 waveform. Equipment that
does not support auto-negotiation must be configured to
exactly match the mode of operation as the link partner or
else no link can be established.
1000Base-T requires auto-negotiation. The IEEE Ethernet
standard does not support setting a speed to 1000 Mbps
with the speed command without auto-negotiation. E-
Series line cards support both full-duplex and half-duplex
1000BaseT.
Values are:
• 0 - Manual MDI
• 1 - Manual MDIX
• 2 - N/A
• 3 - Auto MDI/MDIX
Interfaces