Set Comm-List Delete - Dell Z9500 Reference Manual

set comm-list delete

To remove the specified community list from the BGP route's COMMUNITY attribute, configure a filter.
Z9500
Syntax
set comm-list community-list-name delete
To insert the community list into the COMMUNITY attribute, use the no set
comm-list community-list-name delete command.
Parameters
community-
list-name
Defaults Not configured.
Command ROUTE-MAP
Modes
Command
This guide is platform-specific. For command information about other platforms,
History
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version
9.2(1.0)
8.3.19.0
8.3.11.1
8.3.7.0
8.1.1.0
7.8.1.0
7.6.1.0
7.5.1.0
6.1.1.0
Usage
The community list used in the set comm-list delete command must be
Information
configured so that each filter contains only one community. For example, the filter
deny 100:12 is acceptable, but the filter deny 120:13 140:33 results in an
error.
If the set comm-list delete command and the set community command
are configured in the same route map sequence, the deletion command (set
comm-list delete) is processed before the insertion command (set
community).
Access Control Lists (ACL)
Enter the name of an established Community list, up to 140
characters.
Description
Introduced on the Z9500.
Introduced on the S4820T.
Introduced on the Z9000.
Introduced on the S4810.
Introduced on the E-Series ExaScale.
Increased the name string to accept up to 140 characters.
Prior to 7.8.1.0, names are up to 16 characters long.
Introduced on the S-Series.
Introduced on the C-Series.
Introduced on the E-Series.
307