ingress-port
enable
Defaults
IP 4-tuple (IP SA, IP DA, Source Port, Destination Port)
Command
CONFIGURATION
Modes
Command
This guide is platform-specific. For command information about other platforms,
History
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version
9.2(1.0)
8.3.19.0
8.3.11.1
8.3.10.0
8.3.7.0
7.6.1.0
7.5.1.0
Usage
By default, the system distributes incoming traffic based on a hash algorithm using
Information
the following criteria:
•
•
•
•
Related
hash-algorithm ecmp
Commands
management route
Configure a static route that points to the Management interface or a forwarding router.
Z9500
Syntax
management route {{ip-address mask | {ipv6-address prefix-
length}} {forwarding-router-address | managementethernet}
IPv4 Routing
Enter the keywords to distribute traffic based on the
following:
•
enable — Takes the source port into consideration when
doing hash computations. This option is disabled by
default.
Description
Introduced on the Z9500.
Introduced on the S4820T.
Introduced on the Z9000.
Added the ingress-port parameter for the S4810.
Introduced on the S4810.
Introduced on the S-Series.
Introduced on the C-Series.
IP source address
IP destination address
TCP/UDP source port
TCP/UDP destination port
— changes the hash algorithm across an ECMP.
927