Show Hardware Layer3 - Dell Z9500 Reference Manual

EID 0x000010cc: gid=0x10,
flags=0x10202, Installed, Enabled
DstMac
StageEgress
param2=0(0), param3=0(0)}
{Packets}
--More--

show hardware layer3

Display Layer 3 ACL or QoS data for a Z9500 line card and port pipe.
Z9500
Syntax
show hardware layer3 {acl | qos} linecard slot-id port-set
port-pipe
Parameters
acl | qos
linecardslot-id
port-set port-
pipe
Defaults none
Command EXEC Privilege
Modes
Command
This guide is platform-specific. For command information about other platforms,
History
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version
9.2(1.0)
8.3.19.0
8.3.11.0
8.3.7.0
7.8.1.0
664
slice=3, slice_idx=0x2, part =0 prio=0x10cc,
tcam: color_indep=0,
Offset: 90 Width: 48
DATA=0x00000180 c2000000
MASK=0x0000ffff ff000000
action={act=DropCancel, param0=0(0), param1=0(0),
policer=
statistics={stat id 65
Enter either the keyword acl or the keyword qos to select
between ACL or QoS data.
Enter the linecard slot-id parameters to specify a
Z9500 line card. The range of slot IDs is from 0 to 2.
Enter the keywords port-set port-pipe parameters to
specify a port pipe (set of ports) on a line card. The range of
port-pipe numbers is: 0 to 2 on line card 0; 0 to 3 on line
cards 1 and 2.
Description
Introduced on the Z9500.
Introduced on the S4820T.
Introduced on the Z9000.
Introduced on the S4810.
Introduced on the S-Series.
slice = 3 idx=1 entries=1}
Debugging and Diagnostics