Dell Z9500 Reference Manual page 400

Hide thumbs Also See for Z9500:

Table of Contents

Not configured.

This guide is platform-specific. For command information about other platforms,

refer to the relevant Dell Networking OS Command Line Reference Guide.

The following is a list of the Dell Networking OS version history for this command.

You can assign up to 256 peers to one peer group.

When you add a peer to a peer group, it inherits all the peer group's configured

parameters. A peer cannot become part of a peer group if any of the following

commands are configured on the peer:

A neighbor may keep its configuration after it was added to a peer group if the

neighbor's configuration is more specific than the peer group's, and the neighbor's

configuration does not affect outgoing updates.

A peer group must exist before you add a peer to it. If the peer group is disabled

(shutdown) the peers within the group are also disabled (shutdown).

clear ip bgp

neighbor peer-group (creating group)

show ip bgp peer-group

Enter the name of a configured peer group.

Introduced on the Z9500.

Introduced on the S4820T.

Introduced on the Z9000.

Introduced on the S4810.

Introduced on the S-Series.

Introduced on the C-Series.

neighbor advertisement-interval

neighbor distribute-list

neighbor filter-list

neighbor route-map

neighbor route-reflector-client

neighbor send-community

— resets BGP sessions.

— views BGP peers.

— creates a peer group.

Border Gateway Protocol