Debug Ip Igmp - Dell Z9500 Reference Manual

interface
interface
Command EXEC
Modes
Command
This guide is platform-specific. For command information about other platforms,
History
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version
9.7(0.0)
9.0.2.0
8.3.19.0
8.3.11.1
8.3.7.0
7.6.1.0
7.5.1.0
E-Series legacy
command

debug ip igmp

Enable debugging of IGMP packets.
Z9500
Syntax
debug ip igmp [vrf vrf-name] [group address | interface]
•
•
Parameters
vrf vrf-name
776
Enter the following keywords and slot/port or number
information:
• For a 10-Gigabit Ethernet interface, enter the keyword
TenGigabitEthernet then the slot/port information.
• For a 40-Gigabit Ethernet interface, enter the keyword
fortyGigE then the slot/port information.
• For a port channel interface, enter the keywords port-
channel then a number.
• For a VLAN interface, enter the keyword vlan then a
number from 1 to 4094.
Description
Added support for VRF. Introduced on the S6000-ON.
Introduced on the S6000.
Introduced on the S4820T.
Introduced on the Z9000.
Introduced on the S4810.
Introduced on the S-Series.
Introduced on the C-Series.
To disable IGMP debugging, use the no debug ip igmp [vrf vrf-name]
[group address | interface] command.
To disable all debugging, use the undebug all command.
(OPTIONAL) Enter the keyword vrf followed by the name of
the VRF to enable debugging of IGMP packets corresponding
to that VRF.
Internet Group Management Protocol (IGMP)