Ip Proxy-Arp; Ip Route - Dell Z9500 Reference Manual

ip proxy-arp

Enable proxy ARP on an interface.
Z9500
Syntax
ip proxy-arp
To disable proxy ARP, use the no ip proxy-arp command.
Defaults Enabled.
Command INTERFACE
Modes
Command
This guide is platform-specific. For command information about other platforms,
History
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version
9.2(1.0)
8.3.19.0
8.3.11.1
8.3.7.0
8.1.1.0
7.6.1.0
7.5.1.0
6.1.1.0
Related show ip interface
Commands

ip route

Assign a static route to the switch.
Z9500
Syntax
ip route {destination mask {ip-address | interface [slot/port]
| [tunnel tunnel-id] [distance] | [permanent] | tag tag-value}}
To delete a specific static route, use the no ip route destination mask
command.
IPv4 Routing
Description
Introduced on the Z9500.
Introduced on the S4820T.
Introduced on the Z9000.
Introduced on the S4810.
Introduced on the E-Series ExaScale.
Introduced on the S-Series.
Introduced on the C-Series.
Introduced on the E-Series.
— displays the interface routing status and configuration.
921