Mac Access-List Standard - Dell Z9500 Reference Manual

mac access-list standard

To configure a standard MAC ACL, name a new or existing MAC access control list (MAC ACL) and enter
MAC ACCESS LIST mode. Also refer to the Commands Common to all ACL Types section and the
Common MAC Access List Commands section.
Z9500
Syntax
mac access-list standard mac-list-name
To delete a MAC access list, use the no mac access-list standard mac-
list-name command.
Parameters
mac-list-name
Defaults Not configured.
Command CONFIGURATION
Modes
Command
This guide is platform-specific. For command information about other platforms,
History
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version
9.2(1.0)
8.3.19.0
8.3.11.1
8.3.7.0
8.1.1.0
7.8.1.0
7.6.1.0
7.5.1.0
6.1.1.0
Usage
The system supports one ingress and one egress MAC ACL per interface.
Information
The number of entries allowed per ACL is hardware-dependent. For detailed
information on the number entries allowed per ACL on the Z9500, refer to the
Content Addressable Memory (CAM) chapter in the Z9500 Configuration Guide.
Example
Dell(conf)#mac-access-list access-list standard TestMAC
Dell(config-std-macl)#?
deny
Access Control Lists (ACL)
Enter a text string as the name of the standard MAC access
list (140 character maximum).
Description
Introduced on the Z9500.
Introduced on the S4820T.
Introduced on the Z9000.
Introduced on the S4810.
Introduced on the E-Series ExaScale.
Increased the name string to accept up to 140 characters.
Prior to 7.8.1.0, names are up to 16 characters long.
Introduced on the S-Series.
Introduced on the C-Series.
Introduced on the E-Series.
Specify packets to reject
269